Skip to content
Bath Plumber

Guides

Doing your own plumbing in Ontario and checking who you hire

What Ontario's trade rules mean for a Bath homeowner with a wrench in hand, when the township needs a permit, and how to check a plumber before any work starts.

6 min read Updated November 17, 2026.

Most plumbing questions start small: a toilet that runs all night, a tap that drips, a sump pump that sounds rough in the spring. Before deciding whether to fix it yourself or call someone, it helps to know what Ontario says about who does plumbing, when Loyalist Township wants a permit, and how to tell a careful plumber from a careless one.

What does Ontario say about who does plumbing?

Plumber is a compulsory trade in Ontario. To practise it, a person must hold the provincial qualification for the trade, a provisional one, or a registered training agreement as an apprentice, and they must appear on the Skilled Trades Ontario Public Register. That rule is about working as a plumber: doing plumbing for other people as a trade.

The work itself is governed by Part 7 (Plumbing) of Ontario's Building Code, Ontario Regulation 163/24, made under the Building Code Act, 1992. Those rules apply to the pipes in your house whoever puts them in.

Whether a homeowner may do a particular job on their own house is a question for the township's building department, and it is worth asking before you buy the parts rather than after.

When does a job in Bath need a permit?

Under the Building Code Act, 1992, a permit from the municipality's chief building official is needed to construct a building, and the Act's definitions cover installing, extending, or materially altering or repairing plumbing. In practice that means new plumbing and changes to drains generally need a building permit. Loyalist Township's building department says whether a given job does.

Jobs that usually fall on the permit side include:

  • Adding a bathroom or moving a sink, toilet or shower to a new spot
  • Changing or extending drain lines, including in a basement finish
  • Installing a backwater valve
  • Replacing a section of the sewer line between the house and the street

If you are unsure, call the building department and describe the job. It is a short conversation, and it saves a lot of trouble when you sell the house or make an insurance claim.

What can a homeowner safely do without help?

Plenty of everyday work is within reach and needs no permit:

  • Finding the main shut-off valve and making sure it turns. Do this now, not on the night a pipe lets go.
  • Replacing a toilet flapper or fill valve, or cleaning a faucet aerator
  • Plunging a toilet or clearing a sink trap by hand
  • Testing the sump pump by pouring a bucket of water into the pit and watching it start and stop
  • Draining and shutting off outside taps before winter

It is also safe to look at your pipes. Knowing what you have helps you decide what to do, and in Bath the answer depends a lot on when the house was built.

Which pipes is a Bath house likely to have?

In the old village core along Main Street, Academy Street, Church Street, Davy Street and Lodge Street, houses date from the 19th century, and their plumbing has been added and altered over generations. Galvanized steel or lead water lines, cast-iron stacks and clay sewer pipe are typical. Low pressure, root-blocked drains and damp basements are the usual complaints. Don't start cutting into pipe yourself in these houses: old galvanized threads crack, and one repair often exposes the next.

In Loyalist Estates, off Country Club Drive, most houses date from the 1990s. Copper water lines are common, but some have grey polybutylene, which tends to leak at its fittings. If you see grey plastic pipe at the water heater or under a sink, leave the fittings alone and have them looked at.

In Windermere Estates and the later phases of Loyalist Country Club Estates, houses from the 2000s onward have PEX water lines, with Kitec in some of the earlier ones. Many have a sump pit and a backwater valve. Here the work is more often a tired sump pump or a builder-grade water heater than failing pipe.

Which jobs should go to someone qualified?

Some work carries rules that are easy to miss:

  • Gas water heaters. In Ontario, fuel-fired appliances must be installed and serviced by a contractor registered with the Technical Standards and Safety Authority, using qualified gas technicians, under Ontario Regulation 212/01. This is not homeowner work.
  • Shower and tub mixing valves. The Building Code limits water from a shower head or into a bathtub to 49 degrees Celsius (Article 7.2.10.7.). A valve set wrong scalds.
  • Backwater valves. Article 7.4.6.4. requires one where drains may be subject to backflow, such as fixtures below the level of the street. Placement and access matter, and so does the permit.
  • Sump pump discharge. The township's storm and sanitary systems are separate, and its sewer-use by-law has barred sump water and roof run-off from the sanitary sewer. Send the discharge to the yard or the storm system, not a laundry tub or floor drain.
  • Any digging. A locate must be requested through Ontario Dig Authority before you dig, and the request costs nothing. Public locates do not mark private lines such as your own sewer, so that needs separate care.

How do you spot a plumber who is not what they claim?

Most plumbers are straightforward. The warning signs are fairly consistent:

  • They are not on the Skilled Trades Ontario Public Register, or they will not give a full name you can look up
  • They suggest skipping the permit to save time or money
  • They will not put a price in writing before starting
  • They recommend replacing a lot of pipe but cannot show you why, with photos, the old part or camera footage of a drain
  • They push for a decision on the spot, especially at night, when a shut-off valve would let you wait until morning
  • They want cash only and offer no written invoice

How do you avoid paying more than you should?

A few habits protect you on any job:

  • Check the register first. It takes a minute and settles the qualification question.
  • Ask for a written price and approve it before any part goes in. If the job changes once the wall is open, ask for the new number in writing too.
  • Ask who arranges the permit, if one is needed, and keep a copy.
  • Ask to see the problem. A camera inspection of a sewer line, for example, should come with footage you can watch.
  • For a large job, such as a sewer replacement or repiping an old house, a second opinion is reasonable.
  • On a new water heater or sump pump, ask for the manufacturer's warranty papers and register the unit yourself.
  • Keep invoices with the house records. In a hard-water town like Bath, where the township's own report classes the Lake Ontario supply as hard, water heaters wear out on a schedule, and knowing the install date helps the next decision.

What if you would rather hand it over?

That is a sensible choice for anything involving gas, drains, old pipe or a permit. At Bath Plumber, work is performed by licensed plumbers (306A Certificate of Qualification), and the price is written down for you to approve first. For gas water heaters, the same applies: Gas work is performed by TSSA-certified gas technicians.

If a fixture, leak or old pipe in your house needs attention, see plumbing repairs.

Still have a question?